Skip to main content

Grumman JRF-5 Goose - Part 3

Thank you for your kind words !

I am very slow building this model, mainly explained by my wedding and the amount of work this bird requires. But I am still having fun, no rush .

Wings attached to the fuselage

I made a big hole for the landing light.

There is a big gap on the left wing (did I do that ?). I think I will use cyano gel to correct this problem

Another big gap to fill... Great I love that...

... and more work to adjust the canopy

Resin exhausts. I guess you see the problem here...

... I made the 2 exhausts similar and I made the little thingy smaller and drilled a hole

The wheels being to thin I added some styrene sheet ( 0.25mm)

To finish, I also corrected the rudder by adding some styrene on the lower part:

and added 2 small metal rods on the stabilizers to make my life easier

Hope you enjoy and thanks for reading ;)


Popular posts from this blog

Messerschmitt Bf-109 E3 Walkaround

Walkaround of the Messerschmitt Bf-109 E3 (J-355; Werk NummerlFactory Number 2422) exhibited at the Swiss Air Force Museum at Dubendorf Air Base near Zurich, Switzerland. My wife and I visited this museum and although I was more enthusiastic than her I think she appreciated it :)

D-3801 Morane Saulnier MS 406 Walkaround

After the Bf-109, here is a short walkaround of the Adolph Saurer AG license-built D-3801 Morane Saulnier MS-406 also exposed at the Swiss Airforce museum at Dubendorf (Switzerland). One advice, if you go in Switzerland say D-3801, not M.S. 406 or you will have to handle a diplomatic issue  - n'est ce pas GĂ©rard :)

Below are a few pictures of the cockpit taken through the windows ...

Northrop F-5E Tiger II - Walkaround (Swiss Air Force)